|
 |
 |
|
|
 |
|
|
|
| Q: |
Why does my AP only have the maximum power settings of 14dBm? |
| A: |
The TX output power settings in your AP works in substraction system. The "Max-0" settings is the highest. The "Max-14" is the lowest, it means "Maximum minus 14dbm". Therefore, please choose "Max" or "Max-0" for the highest output power. |
|
|
|
|
|
|
| Q: |
After I upgrade to the new firmware, my AP does not response to PING. But I can still get into the AP's web management. |
| A: |
Please go to the web configuration's "Advance Settings-> System Management" page. Then uncheck the "Disable PING from LAN". |
|
|
|
|
|
|
| Q: |
I use WLA-5000AP with firmware 1.04e04 as client mode device. It seems that there is problem to connect with WPA-PSK encryption firmware 1.00e09 of WLA-9000AP ? |
| A: |
We have shifted the firmware of WLA-5000AP to version 2.x.. Please upgrade the firmware for your device to version 2.00e11. This firmware is available on our web site with both Quick Start Guide and user manual at URL: http://www.airlive.com/support/WLA-5000APv2/5000AP-v2.00e11.zip. |
|
|
| Q: |
Why I did not find the 802.11b/g channel or spectrum on the WLAN 1(Radio 1) interface? |
| A: |
As built for backbone transmission application device, by definition, WLA-9000AP provide only 802.11a band on the WLAN 1(Radio 1), therefore, 802.11a spectrum is available on both WLAN interfaces, 802.11b/g frequencies are available only on the WLAN2 interface. |
|
|
|
| |
